Configuration

1) Plug in your stereo 3.5mm audio cable into the Audio Input connector on the front panel. (Not included but available in the website store).

2) Plug in your DMX cable into the DMX Output connector on the front panel. (Not included but available in the website store).

3) First - Plug in the 12VDC Power Pack into the 12V power input connector on the front panel. (Included). Red power led on front panel will light up if properly connected.

*Do Not Swap the 2 Power Packs when plugging them in as it could prevent the unit from powering up to the proper levels*.

4) Second - Plug in the 9VDC Power Pack into the 9V power input connector on the front panel. (Included).

*Do Not Swap the 2 Power Packs when plugging them in as it could prevent the unit from powering up to the proper levels*.

(Power off in the reverse sequence).

5) Send your stereo audio signal to the unit.

6) Enjoy the lightshow!!!

Power Supply Data:

12 Volt Power Pack

Wattage: 24 W, continuous

Input voltage: 100 - 240 Vac, 50/60 Hz, 0.65 A max

Output voltage: 12 Vdc

Output current: 2 A

Efficiency: DoE Level VI

Safety: UL 62368-1

9 Volt Power Pack

Form: Wall Mount (Class II)

Input Type: Fixed Blade

Voltage – Input: 100 ~ 240 VAC

Voltage – Output: 9V

Current - Output (Max): 1A

Power (Watts): 9 W